ZYC012
Specifications
Circuits | 1-18 circuits |
Operating Speed | 0-300rpm |
Working Temperature | |
Working Humidity | 60%RH or higher |
Electrical: | |
Voltage Rating | 240VAC/DC |
Current Rating | |
Dielectric Strength | ≥500V@50Hz between each circuit |
Insulation Resistance | 1000MΩ@ 500VDC |
Electric Noise | ≤ |
Mechanical: | |
Contact Material | Gold--Gold |
Lead Wire Size | AWG30 silver plated copper UL Teflon® |
Lead Wire Length | Standard |
Housing Material | Engineering plastic or metal |
Torque | ≤ |
Protection | IP54 or higher |
Installation Guide
1.Capsule slip ring is designed for being installed with flange on a sleeve bracket.
2.Rotor must be concentric driven by a flexible link (such as plastic tube or screw tube). Rotor lead wire can
do as this driver at limited-speed.
3.As the photograph shows, screws with washer can be used to install slip ring, these washers can avoid flange
too tight.
Attentions
1.Slip ring can not support the weight of equipment which connects with it, rotating equipment should be
fastened so that its weight will no fall on the rotor.
2.Slip ring should be used in dry, low dust environment. If used outdoor, shield is necessary.
3.The surface of lead wire should avoid being damaged while equipment rotating, all lead wire can not bear
weight while you put the lead wire in order.
4.No damaging the surface of lead wire while barking its end